The benefit in doing so is a better run with the tool – more comfort and control when you're operating the tool, more consistent wear on the accessory, and of course better results. Sometimes you have to do this several times to get things fully balanced. How is the tool running? When you turn the tool on, if you're getting excessive wobble, turn the tool off, loosen the accessory, pull it out and turn it a quarter turn and reseat it. If the tool seems to be running smoothly, turn it off, add the accessory - making sure you insert the accessory as deeply as possible and pull the EZ Change lever FORWARD to lock that accessory in fully. The tolerances on our tools help us manufacture a tool that is not prone to run out – but we are smart enough to never say never. If you detect something like a wobble or hear anything that is concerning to you, the tool should be sent to our service center for evaluation. Let it run for a few seconds and come up to full speed. To trouble shoot that for yourself, start with the tool with nothing in it. There could be a few things contributing to that. If this doesn't work, consider using the pointed end of a pencil and insert that into the collet nut the correct way – it will push the collet back out of the collet nut and then an accessory will be able to fit in the collet. To remove that, or open it up, take the shank end of the accessory and with the collet nut and collet off the tool, insert the accessory in the silver sleeve you're seeing. You'll know the collet is stuck in the collet nut if you see a silver sleeve in the threaded end of the collet nut. Accessories won't fit in there as a result of it being pinched. Chances are the collet is actually pinched in the collet nut – so it is a little stuck in there. If all you see is metal threading, take a closer look at the collet nut. There should be a collet in the end of the tool that extends past the metal threading. Keep holding it down, and unthread the collet nut. To do that, hold down the shaft lock button on the nose of the tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |